ESP8266-01 IOT SMART TIMER FOR HOME AUTOMATION

• Power up the unit
• The LED will start to flash rapidly
• Press the MODE/SETUP button
• When the LED turns off, release the button
• Wait a few seconds, then open your smartphone or device WiFi connections
• A new WiFi netword called IoT Timer will be visible
• Select this access point
• Log onto the IoT Timer (no password is required)
• Wait until your device is connected to the IoT Timer network
• Open up any internet browser
• In the address bar, type in the following IP address - 192.168.4.1
• WiFiManager console will open
• Select Configure WiFi
• A list with available WiFi networks points will be displayed
• Select the required WiFi network, and type in the password
• Next, enter the IP address you want to use to connect to the IoT Timer
• Enter the Default Gateway IP address, followed by the mask
• Once all the settings are done, click on the Save button
• A new window will open to confirm the new credentials were saved
• Close your browser

IoT Timer 

參考資料:

http://www.instructables.com/id/ESP8266-01-IoT-Smart-Timer-for-Home-Automation/